[TheMike]

Sorry…I´m to unexperienced…I somewhere read about the mintemp-error and setted the mintemp in Firmware to “-5”. I was able to fool the homing and now I can jog around !! :-))

Thanks again,
Mike

[TheMike]

Hi,

unfortunately I had no success.
After connecting with Pronterface I set heaters off, pushed on homing button and shorted the x-,y-,z-max subsequently.

Here´s the serial output:

Reset.
Setting hotend temperature to 0.000000 degrees Celsius.
Setting bed temperature to 0.000000 degrees Celsius.
X:-115.96Y:-28.84Z:210.00E:0.00
SCARA Theta:112.84 Psi+Theta:211.67
SCARA Cal – Theta:112.84 Psi+Theta (90):8.82
SCARA step Cal – Theta:269.57 Psi+Theta:236.08
Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
No movement – Home first…
X:-115.96Y:-28.84Z:210.00E:0.00
SCARA Theta:112.84 Psi+Theta:211.67
SCARA Cal – Theta:112.84 Psi+Theta (90):8.82
SCARA step Cal – Theta:269.57 Psi+Theta:236.08

Perhaps it´s because of unknown errors at startup?:

Connecting…
start
Printer is now online.
echo: External Reset
Marlin 1.0.0
echo: Last Updated: May 31 2015 13:03:02 | Author: (qharley, Morgan SCARA armlevel)
Compiled: May 31 2015
echo: Free Memory: 3600 PlannerBufferBytes: 1232
echo:Using Default settings:
echo:Steps per unit:
echo: M92 X215.00 Y215.00 Z100.00 E450.00
echo:Scaling factors:
echo: M365 X1.00 Y1.00 Z1.00
echo:Maximum feedrates (mm/s):
echo: M203 X300.00 Y300.00 Z300.00 E45.00
echo:Maximum Acceleration (mm/s2):
echo: M201 X400 Y400 Z400 E8000
echo:Acceleration: S=acceleration, T=retract acceleration
echo: M204 S9000.00 T3000.00
echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum xY jerk (mm/s), Z=maximum Z jerk (mm/s)
echo: M205 S0.00 T0.00 B20000 X10.00 Z10.00 E5.00
echo:Home offset (mm):
echo: M206 X0.00 Y0.00 Z0.00
echo:PID settings:
echo: M301 P22.20 I1.08 D114.00
Error:0
[ERROR] Error:0

: Extruder switched off. MINTEMP triggered !
Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
[ERROR] Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)

echo:SD init fail

[TheMike]

Dear Quentin,
thanks for help, I will try tomorrow !

Kind regards,
Mike

[Author]

Posts