[Ron Hunt]

I had the same issue. I used the cut off end (downfall) from the rods and worked the bearing into their seats. It took some work to get the bearings both seated and aligned. Using the scrap piece of rod really helped give me leverage without being concerned about damaging the rods themselves

[Ron Hunt]

Little late

[Ron Hunt]

Your build looks great!

Cheers!

[Ron Hunt]

If you covered this I apologize for not catching it. Did you install the jumpers under the stepper controller on the RAMPS board?

[Ron Hunt]

Thank you for the comment, it’s been a pleasure to work on.

[Ron Hunt]

Quentin,

Your elegant scalable mechanism is simply awesome! Thank you for your gift of such an inspirational useful design.

[Ron Hunt]

[Author]

Posts