Posted on Leave a comment

Filament arrived

After running out of PLA a few days ago, I had to continue in ABS. It was a good exercise, allowing me to tune my ABS setting for Morgan a bit, and to make a couple of improvements to the hotend holder.

Some of the upgrades include printability improvements, better bowden support, and improvement of bowden to J-head interface. On Morgan 0 I sometimes have to open the bowden clamp in order to insert the filament into the head. Especially when the filament gets more curved (inside of roll) it does not play well.

More info during the weekend.

Posted on Leave a comment
Leave a Reply

Your email address will not be published.

The CAPTCHA cannot be displayed. This may be a configuration or server problem. You may not be able to continue. Please visit our status page for more information or to contact us.

This site uses Akismet to reduce spam. Learn how your comment data is processed.