- This topic has 2 replies, 2 voices, and was last updated 12 years, 12 months ago by
.
Viewing 2 reply threads
-
Posts
-
-
-
The same question also applies to the m8 40mm bolts
And the m8 60mm bolt
-
You will probably have to use the one that is threaded through, because the captive nuts in the arms goes halfway onto the bolt, and it is not threaded half way. Optionally you could just get a die, and tap the bolts further to where you need it. It would make it a better fit on the bearings, since m8 thread is smaller than 8mm.
-
Viewing 2 reply threads
- You must be logged in to reply to this topic.
