I noticed that the z-bed mount brackets were not created properly… There should be a 8mm and 12mm version in the repository, and it seems that there was only the 12mm, not named as such…
So! If you are building the 8mm rod version, you would probably have to reprint the correct bracket in order to make everything fit together.
Sincere apologies…
The OpenSCAD models are unchanged.
Get your updated Morgan STL files from Github.
I guess I should have caught that. I modeled all the parts up to that one. Maybe I am psychic and I knew I needed to wait on that one. 🙂
And I am printing the parts here without a care in the world. It is a good thing I checked out a fresh copy from Git to check it, right?
Cannot wait to see your work!
Q
Hi Quentin,
Could you post some pictures to show where need to mount the endstops? It’s very important for Morgan movement right?
Thanks
I think it is time for a short video.
Give me a couple of hours.
Here it is…
Great job Quentin!
I’ve never used hall effect sensors before…So, could you tell me what type of sensors and where can I buy?
Website link is OK.
Thanks for your amount attention.